Fix My Speaker Dust
Eject Water & Dust From Your Phone Speaker
Use targeted sound frequencies to clear trapped water and loose dust from your phone speaker in seconds. No app or signup required.
Speaker Cleaning
High output enabled. Lower the volume if the sound feels harsh and point the speaker downward.
Simple steps. Clear sound.
Clean Your Speaker in 60 Seconds
Choose a mode, fine-tune the sound, and let targeted frequencies help push trapped water and loose dust away from the speaker grille.
Choose a Cleaning Mode
Pick Water Eject, Dust Removal, Deep Clean, or Frequency Sweep for the sound pattern you need.
Set Frequency & Volume
Adjust anywhere from 20–2000 Hz and set a comfortable volume before starting the cycle.
Run the 60-Second Cycle
Point the speaker downward, press start, and let the selected frequency pattern complete its cycle.
Made for simple, everyday use
Powerful Controls.
Nothing Complicated.
Everything stays in your browser. Choose the sound pattern, adjust the frequency and volume, then run a focused 60-second cleaning cycle.
Full Frequency Control
Fine-tune the cleaning sound from deep low tones to sharp high frequencies.
Private by Design
The cleaning sound runs locally in your browser. No personal files or audio recordings are uploaded.
Four Cleaning Patterns
Switch the sound behavior without leaving the tool.
Works Across Devices
Responsive controls for phones, tablets, laptops, and modern web browsers.
Independent Volume
Set the tool output separately and lower it anytime if the tone feels harsh.
Start in One Tap
No installation or account. Open the tool and begin a 60-second cycle.
Ready when you are. Start with Water Eject and adjust the frequency if needed.
Follow the sound
See How the 60-Second Cycle Works
Start with the problem
Water Can Leave Your Speaker Sounding Muffled
After rain, a splash, or a small spill, droplets may remain around the speaker grille and reduce sound clarity.
Helpful answers
Questions Before You Press Play?
Find the right frequency, volume, and cleaning mode before starting your first 60-second speaker cleaning cycle.
Quick tip Remove the phone case and point the speaker downward before starting.
01 How does Fix My Speaker Dust work?
The tool plays controlled sound patterns through your device speaker. These vibrations can help move trapped water droplets and loose surface particles away from the speaker grille.
02 Can speaker-cleaning sound remove water?
It can help eject small amounts of water trapped around the speaker grille after rain, splashes, or light moisture. It cannot repair internal liquid damage or replace professional service after full submersion.
03 Can this tool remove dust as well?
The Dust Removal and Frequency Sweep modes may help loosen light particles near the grille. Compacted dirt or material inside the phone may still require careful professional cleaning.
04 Which frequency should I choose?
Start with the default Water Eject setting. If needed, adjust gradually within the 20–2000 Hz range or use Frequency Sweep to move automatically through a wider selection of tones.
05 How loud should I set the volume?
Begin at a comfortable level and increase it gradually. A louder setting may create stronger vibration, but you should lower the volume immediately if the sound feels harsh or the speaker begins to distort.
06 Does it work on iPhone and Android phones?
Yes, the cleaner is designed for modern mobile browsers that support web audio. It also adapts to tablets and computers, although available volume and sound output depend on the device and browser.
07 How many 60-second cycles can I run?
Run one cycle, test the speaker, and repeat only if needed. Give the speaker a short break between cycles and stop if you notice distortion, unusual heat, or any worsening sound.
08 Why can I not hear the cleaning sound?
Check the media volume, turn off silent mode where applicable, disconnect Bluetooth headphones or speakers, and tap Start Cleaning again so the browser can allow audio playback.
09 Is any audio or personal data uploaded?
No. The cleaning tones are generated locally in your browser. The tool does not need your microphone, does not record audio, and does not upload personal files.